close
close

How To Clean Maytag Washing Machine Filter Top Loader

How To Clean Maytag Washing Machine Filter Top Loader. Release the black hose from the hose clip, remove the plug, and. In order to prevent water leaks or electrocution, be sure to disconnect your washer from the outlet and turn the water faucets off before starting this repair.

Maytag, whirlpool & Kenmore Washer Pump Filter Diagnostic & Repair from www.youtube.com

I don’t think that it. Mix a solution of warm water and a few drops of dishwashing liquid. Place a broad, flat container beneath the drain pump filter to collect the drain water.

Dip It In Hot Water And Dish Soap Solution And Leave It To Soak For A Few Minutes.

How do i clean my maytag top load washer? Release the black hose from the hose clip, remove the plug, and. Open the lid and dip an old toothbrush into the cleaning solution.

However There Is A Drain Pump Filter, Part #14 Basket And Tub Parts Diagram Mentioned In The Parts List, Which Is There To Trap Lint From Being Pumped Out To The Drain.

Here is how you access and clean. Place a broad, flat container beneath the drain pump filter to collect the drain water. Mix a solution of warm water and a few drops of dishwashing liquid.

Open The Washer Door And Wipe Down The Inside Glass Or Metal With A Damp Cloth And For Front Load, Maytag Washers, Wipe Out The Rubber Seal On The Washer Doors Thoroughly.

Go to the back of the washing machine, then use pliers to disconnect the hot and cold water hoses from the inlet ports (some water may spill out, so it is advised that you keep a rag nearby). When your maytag washing machine is dripping water from the door, this is most likely due to a door seal problem, you need to wipe it down with a damp cloth to remove any debt or debris. Here is how you access and clean the filter in your maytag front.

Step 1 Make Sure The Washer Is Set To The Off Setting.

Finally, run the shortest cycle possible from your. Pull the bottom of the front panel out to release the two tabs at the top of the washing machine. Make sure it’s clean, so you don’t spoil your clothes.

The Front Panel Must Be Removed And The Pump Filter Cleaned Of All Debris.

Afterwards when simply let it soak for an hour. Use a small brush to clean the filter before replacing it. Close the door and select your washer’s cleaning cycle.

Leave a Reply

Your email address will not be published.