close
close

How To Remove A Bathtub And Install A Shower

How To Remove A Bathtub And Install A Shower. If you have one, loosen it with an allen wrench. All you have to do is unscrew the strainer and remove the linkage from the overflow drain.

Great Concept Remove Bathtub Spout rssmix.info from rssmix.info

Once that foam hardens the only way to separate the tub is with a. Measure your bath and check plumbing many rectangular shower enclosures are designed to fit the footprint of a standard straight bath. Insert the drain key onto the drain crosshairs and use a wrench or pliers to clamp onto the key.

Check The Tub Spout For A Set Screw.

Lower the tub into place so that the continuous flange fits against the wall studs and rests on 1'x4' or 2'x4' supports. Remove the tub drain flange unscrew the bathtub drain flange, which is the part. Once that foam hardens the only way to separate the tub is with a.

Also Remove Any Moulding Around The Sides.

Follow the manufacturer's directions to install the shower pan. Mark the drainpipe riser at the correct height, then remove the drain pan and trim down the drain pipe. Then, turn the drain key counterclockwise to unscrew the flange.

Test That The Water Is Turned Off By Trying To Turn On The Water In The Bathtub.

Remove the tub spout since this will be on a portion of the wall you'll be cutting away. First, you’ll need to remove the 2×4 stud on the side of the tub opposite of the drain that the side tub flange was attached to (see the video for more detail). Using a pry bar or a screwdriver, remove all of the screws or nails around the tub.

Here's How To Replace Your Bath With A Shower 1.

Use a screwdriver or pry bar to remove the screws or nails that attach the tub flange to the wall studs. With the hammer or cordless drill, remove the fasteners holding the horizontal bathtub stringer from the wall studs. Measure your bath and check plumbing many rectangular shower enclosures are designed to fit the footprint of a standard straight bath.

Anchor The Tub To The Enclosure With.

All you have to do is unscrew the strainer and remove the linkage from the overflow drain. Use a strainer wrench to remove the drain flange. First, turn off the electrical breakers to the bathroom and also the water in case you accidentally rupture a pipe.

Leave a Reply

Your email address will not be published.