How To Reset Blink Camera To Factory Settings. Reset—press and release the recessed reset button. Www.beatcameraa.com the blink sync module can be reset and rebooted to setup mode by pressing and holding the reset button until a red light shows.
The length of motion clips to be recorded; Open up the blink app and click on the ? Wait for the ip camera to reboot.
Table of Contents
Remove Both Batteries From The Camera For 10 Seconds.
Open up the blink app and click on the ? To reset a blink mini camera, press and hold the reset button at the bottom of the camera. Blink mini can also be connected to the sync module and if your blink mini is connected to the sync module then use the above steps for resetting using the sync module.
The Length Of Motion Clips To Be Recorded;
Reset—press and release the recessed reset button. Adjust sensitivity then test by creating motion alerts to achieve the right balance for your needs. Hold down the reset button for up to 30 seconds, or until the light flashes on.
The Blink Mini Has A Reset Button On The Bottom Side Of The Camera, Which May Be Necessary To Use When You Add It To A New Or Existing Blink System.
Select menu → setup → navigate to setting reset → camera settings reset or initialize. For best results, make sure the blink mini is plugged in when performing the reset. Select menu → settings → initialize → ok.
The Resetting Process Will Start.
Hold the button until the light turns red. Resetting is completed when you see the solid blue and green light. To reset the blink module, press and hold the reset button for at least 10 seconds.
Camera Reset Instructions Grab A Pin Or Paperclip As You'll Need This During The Process.
Select menu → setup → initialize → reset default or factory reset. This can be set between 5 and 60 seconds for indoor (gen 1) , xt and xt2 cameras. All settings will be restored to factory default.