close
close

How To Reset Maintenance Light On Toyota Corolla 2016 References

How To Reset Maintenance Light On Toyota Corolla 2016 References. Step 2 press the odo/trip button to display odo. With the vehicle running you should set the odometer to trip a by pressing the disp button repeatedly step number two is to turn off the ignition

How to reset a maintenance light on a 2013 Toyota Corolla YouTube from www.youtube.com

Place odometer on trip a 3. Turn the vehicle completely off. Ensure trip metre a reading is.

Turn Key To The On Position While Holding The Trip Button;

Hold the button in until the display cycles through and returns to showing the odometer. Put the key in the ignition turn to the “on” position depress the odometer button until your dash readout shows trip a switch the car off but keep the odometer button held down. If that doesn’t work, try repeating those steps.

Release The Button And Start The Engine.

The maint reqd light will turn off posted on dec 07, 2009 While pressing the button to reset the trip, turn the key back to the “on” position. While holding the button in, turn the ignition key to on.

Continue To Hold The “ Trip ” Button While Switching The Ignition To “ On ” Without Starting The Engine.

Step 2 press the odo/trip button to display odo. Continue to hold down the trip odometer reset button. Find the vehicle settings then you’ll scroll down until you got the vehicle settings press and hold the ok button so right here you’ll hold down the ok button for about three seconds select scheduled maintenance highlight the schedule maintenance and then press ok select yes when a confirmation message appears, select yes to perform reset data

To Disable This Light Without Unplugging The Battery:

With the odometer button held down, turn the key to the on position again. Hold in the same button you used in step 1. Turn the ignition key to 'on' and press the odometer button until the display reads odo (not trip a or b).

If The Miles Section Of The Odometer Suddenly Flashes Zero, You've Successfully Reset The Maintenance Light.

Then the maintenance required light should blink and go out. To reset the 2016 toyota corolla maintenance light after an oil change, please follow these instructions: Press the odo/trip button to display to trip a.

Leave a Reply

Your email address will not be published.