close
close

How To Reset Oil Change Light Jeep Grand Cherokee References

How To Reset Oil Change Light Jeep Grand Cherokee References. Turn the ignition to on, with the engine off. Turn the ignition to the “on” notch, without starting the engine.

2014 Jeep Grand Cherokee SRT Oil Light Reset / Service Light Reset from www.youtube.com

Put the transmission in park position and key in on position. Oil life monitor reset procedure frequently asked questions. The display should read 100% when it is reset.

Once There, Find The Remaining Oil Life.

The fastest way to reset oil life and is usually used for all jeep models is by step on the gas pedal three times slowly within 10 seconds after turn the ignition to the run position. Use the navigation button in order to select vehicle info. Reset oil change required light on 2008 jeep grand cherokee

Depress The Gas Pedal Three Times.

Repeat this procedure, if the. Slowly fully press and release the accelerator pedal 3 times within 5 seconds. Without holding the brake pedal, press the start/stop button to turn on the electronics.

If You Are Still Having Trouble With Visit The Oil Life Monitor Reset Procedure Frequently Asked Questions (Faq) Page For More Information.

Do not start the engine. This video is about how to: Rb the mechanic assumes no.

On The Steering Wheel, Navigate To The “ Oil Life ” Selection Under “ Vehicle Info “.

Jeep cars oil reset tutorial. Then press & hold the reset button until the mileage resets. Turn ignition to run position, don’t start the engine.

Please Click Oil Reset To See The Process For Other Car.

Put your jeep in “park” and turn off the engine. Put your foot on the accelerator pedal and hit the pedal three times slowly within 10 seconds. Hold down the ok button to reset.

Leave a Reply

Your email address will not be published.